Door Lock

• Method : ASK SINGLE CONVERSION
• Reception frequency : 315MHz(±500KHz)
• Operation temperature : -20°C~60°C
  (condition without freezing and dew condensation)
• Operation humidity : 5~80%
  (condition without dew condensation)

• Slide open battery cover from the main body in(▼) direction and put in 2AA sized alkaline batteries
• Firmly close battery cover at the main body
• After installing device, always check whether the remote control is functioning properly with a person at the inside part of the door(Check respectively at both sides of the doors).
  -Transmission distance from the remote control
  -Best location for frequency transmission and receipt
  -Adjust direction of the antenna(Best location will be 90 from the main body but this may differ according to the environment.)
  -Alarm tone will ring from the main body when locked or open
• Lock. Open dial tone of product
  -Lock button→single touch→'beep--'→main body locks up
  -Open button→single touch→'beep, beep, beep'→open main body

Alarm to inform time to change the battery

• When the LED starts flickerting every four seconds and there is a cricket sound from the main body, the battery must be changed to a new one immediately

Manual lever

• Manual lever is designed to open easy when pressed with a hand. It is safe for use in emergency situations such as fire

How to register

1. Open battery cover
2. Register button is located at the left center of the battery holder
3. Keep pressing the register button for 2 seconds using a with a thin device
4. LED will start flickering with a beeping tone
5. Press all 4 remote controls for a second until they make a beeping tone
6. Press the register button again for a second until they make a beeping tone
7. Registration completed. Check whether the main body is operating properly.

How to delete

1. Gather all remote controls that can be used when the remote control is lost
2. Register again with the above method
3. Registration for the lost remote control is deleted and thus safe to use

Installation

1. Take off adhesive tape from latch
2. Leave adhesive tape to main body and closely adhere key to the door pillar
3. Detach adhesive tape from the main body
4. Firmly attach main body in designated location
5. After deconstructing the bond, remove assistance bushing
6. Firmly push adhered part to remove air in order to enhance adhesiveness between main body and the key

Confirming product installation

• Test operation with a remote control whether it is accurately installed
• Let alone for 24-hours in order to enhance adhesive power of the adhesive tape

How to disassemble

1. Separate bolt on each sides of the base plate from the main body by using a cross screwdriver
2. Cut off base adhering to the door slowly, pushing forward in a downward move, using fine but tough metal wire
   (It uses same method for the latch)
3. Adhesive tape on the door can be taken off by blowing with a hair dryer.